Natural Alabaster

Naturally Unique Veining

No two pieces of stone are ever the same

Alabaster is a natural stone, so every piece carries its own veining and subtle variation in color. The fixture you receive may therefore differ slightly from the images shown.

Material Genuine Natural Alabaster · Brass Rods, Bands & Canopies Stone cut and polished; metal electroplated and finished.

Finish Brass · BlackAlabaster: natural white in both.

Light source Integrated LED — warm white 3000K Built in — no bulb to buy, fit, or replace.

Power Max 40W

Voltage AC 110–240V

Control Standard wall switch (not included) A dimmable version is available — ask us before ordering. See the note below.

Mounting Ceiling — hardwired, two fixing points

Rating IP20 — indoor, dry locations only No protection against water or steam. Not for bathrooms.

Preparation time 5–10 days Made and inspected at our own workshop before dispatch.

Good to Know

Length 39.4″ 100 cm

Length 47.2″ 120 cm

Overall drop 23.6″ 60 cm · including rods

The design

Nothing Spans Between the Rods

The bar every linear light hides — this one simply doesn't have.

Look closely at almost any long dining light and you will find the same thing: a metal bar running its full length, carrying the wiring and the weight, with a shade hung underneath to hide it. The shade is doing two jobs at once — softening the light, and concealing the structure that holds it up. It has to be deep enough to swallow the bar, which is why so many linear fixtures are bulkier than the light they give.

Two slim rods drop from two separate points on the ceiling, and between them there is only air. Each rod carries its share of the load and its share of the wiring, and because nothing has to be concealed, the stone could be made shallow — a trough rather than a box, flat along the bottom with the sides just rising and the ends turning up.

Shallow is what makes the light behave. A deep shade collects light and lets it out at one opening; a shallow trough spreads it along the whole length of the stone. So what arrives on the table is not two or three bright pools with dim gaps between them, but one continuous band of warmth — the reason a long table under a linear light either works completely or does not work at all.

The two metal bands are the last decision, and the least obvious. Without them the trough would read as one blank strip of glowing stone, and the eye would slide off it. Crossing it at even intervals divides the length into three, giving the proportion something to be measured against — the same reason a long table looks better with three place settings than with an unbroken run of cloth. In brass the bands melt into the warmth and the piece reads as one object; in black they become hard graphic lines against pale stone.

Not directly — and this is the most important thing to know before ordering.

It hangs from two slim rods fixed at two separate points on your ceiling, not one canopy. That means two holes, two fixings, and wiring run between them.

The fixture is 39.4″ long, and the rule for a linear light is half to two-thirds of the table's length.

So it suits a table of roughly 60–79″. Under 55″ it will overhang both ends and start to look like a beam across the room. Over 90″ it will light the middle and leave the ends dim — for a table that long, two fixtures end to end is the usual answer, and we're happy to advise on the gap between them.

One thing it is not for: a round table. A linear light over a circle leaves two arcs unlit and two ends of the stone doing nothing.

The whole length. The stone glows continuously rather than sending light down from a few visible sources.

That is the difference between this and a row of pendants. What lands on the table is one continuous band of warmth instead of two or three bright pools with dim gaps between them — which matters most at the ends of a long table, where a row of pendants usually runs out of light.

Over a dining table, 30–36″ from the tabletop to the bottom edge of the stone — lower than instinct suggests, but nobody walks under a table. Over a kitchen island, 30–34″ is better, since you stand rather than sit. Anywhere people walk beneath it, keep 7 ft of clearance above the floor. The fixture's own drop is 23.6″ including the rods; if that leaves it too high for your ceiling, longer rods are supplied on request.

Yes, but it has to be specified when you order. (Please contact us if you require a dimmable version.)

No — the LED is built in, running at warm white 3000K. Nothing to source, nothing to match along the length, and no section brighter than another. If it ever stops working, contact us and we'll advise on parts.

To break the length up. Without them the trough would read as one blank strip of glowing stone and the eye would slide straight off it. Crossing it at even intervals divides the length into three, so the proportion has something to be measured against.

They also change the character of the piece. In brass the bands blend into the warm stone and it reads as one object; in black they become sharp graphic lines against pale alabaster.

Because it is quarried, not moulded. The veining running the length of your trough will be its own — and lit from inside, on a piece this long, it is the first thing anyone notices.

Sections may also differ slightly in tone from one another. That is real stone doing what real stone does; a piece that matched the photograph exactly would have to be resin.

The weight is spread across two fixing points rather than hanging from one, which helps — but both of them need to be fixed into the structure above rather than plasterboard alone. Have your electrician confirm each point before installation. Ask us for the exact weight and pass it on.

A soft dry cloth along the stone. Keep water off it — alabaster is porous, absorbs it, and leaves a mark that won't buff out. The trough is open at the top, so dust settles inside it; a dry brush reaches in more easily than a cloth.

The metal bands and rods can take a barely damp cloth followed by a dry one. Switch off and let it cool first. Once or twice a year is plenty.

No. It's rated IP20 — indoor dry rooms only, with no protection against water or steam. Alabaster is porous too, so damp is bad for the stone as well as the wiring. Dining rooms, kitchens, offices and hallways are all fine.

Installation

The Complete Installation Guide

Not sure how to wire it, how high to hang it, or whether you need an electrician? Our full guide walks through every step for US homes.

Read the Full Installation Guide

Free guide · Written for US homes · Opens in a new tab